You need to Read the rules and Join the forums before you can post.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LED Fan Wire Fried and Melted
06-25-2013, 03:29 PM, (This post was last modified: 06-25-2013, 03:33 PM by pedwards.)
#4
LED Fan Wire Fried and Melted
Speaking as an Electrical Engineering Degree holder (aka have no clue what Im talking about, so take anything I say with a grain of salt), they do rate the cables in the case for a certain safety factor. Now for those led cables the current should be minimal, LEDs act like as a virtual resistor (mostly).

So meaning for your wires to ignite and burn, there must have been a decent amount of juice running through those wires. What would help is to inspect the damaged wires and connectors. What do they look like? All charcoal filaments? Any flashes (smoke wise) on the board? Both black and red burnt, only 1? How does the connector look on the cable itself? This of course assuming everything wasn't thrown away.

Hopefully it was a crimp or short in the wires that caused it. If not it may have been something with the board itself. You are right to forego trying it again as the benefit for now is less than causing another flame out.

However Do not use higher rated cables if it doesn't seem standard. What it could do is transfer more juice than designed and the point of failure just changed from the cable to a circuit board.

Anyway curious if you can provide any details, but not necessary if you call the case closed and its working. Although if a warranty issue comes up on any of your components, might be good to establish root cause.

Good luck.
CPU: Intel i7-2600K @4.2GHz Mobo: ASRock P67 EXTREME4 GEN3 RAM: Corsair Vengence 8GB 1600Mhz DDR3 GPU: Sapphire Radeon HD 7970 3GB
SSD: Samsung 830 Series 256GB SATA 6.0Gb/s HDD: Seagate Barracuda 1TB PSU: SeaSonic Platinum-1000 80 PLUS Modular ODD: SONY DVD 24x
CPU Cooler: Thermalright SilverArrow Sound: Creative SB X-Fi Titanium Fatal1ty PCI-E Case: CM Storm Trooper
Reply


Messages In This Thread
LED Fan Wire Fried and Melted - by gamerDD3 - 06-22-2013, 10:26 PM
LED Fan Wire Fried and Melted - by mwhals - 06-23-2013, 11:12 AM
RE: LED Fan Wire Fried and Melted - by PwnBroker - 06-24-2013, 09:36 PM
LED Fan Wire Fried and Melted - by pedwards - 06-25-2013, 03:29 PM
RE: LED Fan Wire Fried and Melted - by PwnBroker - 06-29-2013, 11:26 PM
LED Fan Wire Fried and Melted - by pedwards - 07-01-2013, 01:21 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)